工厂重置头像2.0#

重置为出厂设置的原因 #

您的 ®Nitrokey 被锁定（例如由于多次输入错误的 PIN 码）。
你丢失了你的Nitrokey（在这种情况下，你首先需要一个新的）。
您自行安装了操作系统（如更换硬盘后）。
你的操作系统不能启动

警告

如果你重置你的设备，Nitrokey上的所有数据都将丢失。因此，在执行重置之前，请备份你的数据。

程序 #

将你的Nitrokey连接到NitroPad。
开启NitroPad。
选择 “选项”。

选择 “OEM-Factory Reset /Re-Ownership”。

用 “继续 “确认重置。

您的设置的完整性将被测试，取决于您执行重置的原因，这可能会失败，但无论如何都会继续。

下面的问题都可以用 “默认 “来回答。如果你只想重置你的设备，就按回车键。

Would you like to change the current LUKS Disk Recovery Key passphrase?
 (Highly recommended if you didn't install the Operating System yourself, so that past provisioned passphrase would not permit to access content.
 Note that without re-encrypting disk, a backuped header could be restored to access encrypted content with old passphrase) [y/N]: N

Would you like to re-encrypt LUKS encrypted container and generate new Disk Recovery key?
 (Highly recommended if you didn't install the operating system yourself: this would prevent any LUKS backuped header to be restored to access encrypted data) [y/N]: N

The following security components will be provisioned with defaults or chosen PINs/passwords:

TPM Ownership password
GPG Admin PIN
GPG User PIN

Would you like to set a single custom password that will be provisioned to previously stated security components? [y/N]: N

Would you like to set distinct PINs/passwords to be provisioned to previously stated security components? [y/N]: N

Would you like to set custom user Information for the GnPG key?[y/N]: N

Would you like to set custom user information for the GnuPG key? [y/N]: N

Checking for USB Security Dongle...

Detecting and setting boot device...

Boot device set to /dev/nvme0n1p2

Resetting TPM...

Resetting GPG Key...
(this will take around 3 minuts...)

Changing default GPG Admin PIN

Changing default GPG User PIN

Reading current firmware
(this will take a minute or two)

Adding generated key to current firmware and re-flashing...

Signing boot files and generating checksums