ファクトリーリセットヘッズ2.0¶

工場出荷時設定へのリセットを行う理由 ¶

Your Nitrokey is locked (e.g. due to multiple incorrect PIN entries)
Nitrokeyを紛失した場合（この場合、まず新しいNitrokeyが必要となります。）
You have installed an operating system yourself (e.g. after changing the hard disk)
オペレーティングシステムが起動しない

警告

端末をリセットすると、Nitrokeyのデータはすべて失われます。そのため、リセットを行う前にデータのバックアップを行ってください。

手順 ¶

NitrokeyをNitroPadに接続します。
NitroPadの電源を入れる。
オプション」を選択します。

OEM-Factory Reset /Re-Ownership」を選択します。

Continue（続行）」でリセットを確認します。

セットアップの整合性がテストされます。リセットを実行する理由によっては、失敗する可能性があります。

以下の質問は、すべて「初期設定」で回答できます。デバイスをリセットしたいだけなら、Enterを押すだけです。

Would you like to change the current LUKS Disk Recovery Key passphrase?
 (Highly recommended if you didn't install the Operating System yourself, so that past provisioned passphrase would not permit to access content.
 Note that without re-encrypting disk, a backuped header could be restored to access encrypted content with old passphrase) [y/N]: N

Would you like to re-encrypt LUKS encrypted container and generate new Disk Recovery key?
 (Highly recommended if you didn't install the operating system yourself: this would prevent any LUKS backuped header to be restored to access encrypted data) [y/N]: N

The following security components will be provisioned with defaults or chosen PINs/passwords:

TPM Ownership password
GPG Admin PIN
GPG User PIN

Would you like to set a single custom password that will be provisioned to previously stated security components? [y/N]: N

Would you like to set distinct PINs/passwords to be provisioned to previously stated security components? [y/N]: N

Would you like to set custom user Information for the GnPG key?[y/N]: N

Would you like to set custom user information for the GnuPG key? [y/N]: N

Checking for USB Security Dongle...

Detecting and setting boot device...

Boot device set to /dev/nvme0n1p2

Resetting TPM...

Resetting GPG Key...
(this will take around 3 minuts...)

Changing default GPG Admin PIN

Changing default GPG User PIN

Reading current firmware
(this will take a minute or two)

Adding generated key to current firmware and re-flashing...

Signing boot files and generating checksums